Freeze damage

Above-ground irrigation components are especially exposed during cold weather. Water trapped inside can expand when it freezes and damage housings, fittings or internal parts.

Debris and internal wear

Debris or worn components can prevent internal parts from sealing correctly. A technician can inspect the assembly and surrounding irrigation supply to determine whether repair is practical.

Repair versus testing

Fort Mill Irrigation provides backflow and irrigation-supply repair related to residential sprinkler systems. We do not advertise backflow certification testing.

Winter protection

Our sprinkler winterization service is intended to reduce trapped water in irrigation components before freezing conditions.

Call (803) 710-8008 for irrigation supply or backflow repair in the Fort Mill service area.

The post What Can Cause an Irrigation Backflow Preventer to Leak? first appeared on Fort Mill Irrigation.

Leaks before the zone valves

A leak on a pressurized irrigation supply line can continue whenever the irrigation water supply is on. These leaks may create persistently wet soil or unexplained water use.

Leaks after a zone valve

Lateral piping normally carries pressure while its zone is running. However, a valve that seeps internally can allow water into a zone while the controller is off, sometimes producing drainage or a slowly leaking sprinkler head.

How the leak is isolated

The timing and location of water are important clues. Our sprinkler leak repair process determines whether the problem is supply-side, valve-related or within a particular zone before digging.

Fort Mill homeowners can call (803) 710-8008 for residential irrigation troubleshooting.

The post Can a Sprinkler Leak Make My Water Bill Go Up Even When the System Is Off? first appeared on Fort Mill Irrigation.

Electrical signal versus water flow

The controller sends low-voltage power to the solenoid. The solenoid then allows the valve to respond hydraulically. A valid electrical signal with no water flow narrows the diagnosis but does not identify a single failed part by itself.

Possible causes

A failed or weak solenoid, stuck internal components, debris, diaphragm damage, closed supply or a mechanical valve failure can all produce a dead zone even when controller voltage is present.

Test before replacing the valve

Our sprinkler valve repair approach checks controller output, wiring/solenoid response and valve behavior before recommending parts. If the valve is buried or its wiring path is uncertain, valve locating and wire tracing may be part of the diagnosis.

Need help in Fort Mill or a nearby community? Call (803) 710-8008.

The post Sprinkler Valve Has Power but Will Not Open: What Does That Mean? first appeared on Fort Mill Irrigation.

If only one zone loses pressure

Check for broken heads, underground lateral-line leaks, a valve that is not opening fully, clogged nozzles or too many high-flow heads on the zone. Our low-pressure troubleshooting process compares zone behavior rather than assuming the water supply is the problem.

If every zone loses pressure

System-wide weakness can point toward the irrigation shutoff, backflow/supply components or another upstream restriction. See irrigation supply and backflow repair.

Why replacing heads may not solve it

Changing sprinkler heads can mask a hydraulic problem without correcting its cause. Pressure diagnosis should start with where the loss occurs and whether it affects one zone or the entire system.

Fort Mill Irrigation has serviced residential irrigation systems since 1996. Call (803) 710-8008 for sprinkler troubleshooting.

The post Why Does My Sprinkler System Lose Pressure When a Zone Turns On? first appeared on Fort Mill Irrigation.

Common signs of freeze damage

Watch for water spraying or dripping near the irrigation supply, unusually wet soil, a zone with very low pressure, heads that will not rise, or a system that loses pressure as soon as it runs.

Why diagnosis matters

A weak zone after a freeze is not automatically a broken pipe. A valve problem, supply restriction or damaged component can create similar symptoms. A spring sprinkler start-up that tests the system zone by zone can help isolate freeze-related failures before excavation or parts replacement.

Backflow and irrigation-supply repairs

Fort Mill Irrigation performs backflow and irrigation-supply repair when sprinkler-system components are damaged or leaking. We do not advertise backflow certification testing.

Preventing the same problem next winter

Professional sprinkler winterization reduces the amount of trapped water left in vulnerable irrigation components before freezing weather.

For residential sprinkler troubleshooting in the area, see our Fort Mill sprinkler repair service or call (803) 710-8008.

The post Sprinkler System Not Working After a Freeze: What to Check in Fort Mill first appeared on Fort Mill Irrigation.